My client is a well-established, small but very busy subcontract engineering company who do a variety work for different industry sectors including Aerospace, Motorsport, Medical, Commercial and Oil and Gas industries. They are now looking for a CNC Programmer to Program, Set and Operate Hurco Mills. The ideal candidate will be time served and would preferably have some turning knowledge.What''s on offer: 17.00ph - 21.00ph depending on level of experience40 hours per week Monday to Friday, occasional Saturdays.Paid overtime available.Free onsite parking.20 days holiday plus bank holidays.Duties:Programming, Setting and operation of Hurco milling machines.Program on and offline using OneCNC software.Set up and run machines.Ability to work to very fine tolerances.Attention to detail.Work closely with the turning section to ensure efficiency.The ideal candidate would be willing to help out on lathes when work load is high.Experience:Previous programming/setting/operating experience on CNC Mills.Hurco experience is preferableOffline programming experience preferred.Ideally apprentice trained however experience is more important. Sponsorship will not be offered for this vacancy. Call for more info. ..... full job details .....